Stop Chips Near Hole

Make 10 piles of 4 balls each, in two lines of 5 piles.

Put piles on grass, 5–30 yards from the hole, lines 5–10 yards apart, piles in each line 2 yards apart.

On the green, mark three landing zones in a straight line, 6 feet apart.

Hit 36 chip shots, 12 at each landing zone.

Hit from different piles for each shot. Do 12 shots into the first zone, then 12 into the second, then 12 into the third.

Count shots that land fully in the target zone.

After 36 shots, enter the number of successful shots in the app, out of 36 attempts.

Make 10 piles with 4 balls in each pile, for a total of 40 balls. Put these piles in two lines that cross each other, with 5 piles in each line.

Place the piles on grass, 5-30 yards from the hole. The lines should be 5-10 yards apart, and each pile should be 2 yards apart.

Around the hole, make two circle target zones using string or tees: a small Bullseye (6 feet from hole) and a bigger Bullseye (15 feet from hole).

Hit 36 chip shots, in 3 sets of 12 shots.

For each set, chip towards the Bullseye zones, switching piles each time.

Balls stopping in the small Bullseye count as higher score. Balls in the big Bullseye also count, but less. Both are counted as a successful chip.

When finished, count all balls in the small or big Bullseye out of 36 tries, and enter the total in the app.

Pick a spot in the rough, on an uphill slope, 5–30 yards from the hole.

Put a target at the hole.

Hit 18 chip shots uphill, trying to stop the ball close to the hole.

Move to a downhill spot in the rough, also 5–30 yards from the hole.

Hit 18 chip shots downhill at the same target.

Every 4 shots, check the results and adjust if needed.

Count a success for every ball that finishes close to the hole (like within 3 feet).

Use the same setup for every shot.

After 36 shots, add up your total successes. Enter score in the app, out of 36 attempts.