Save Par with Clutch Chip

Put 40 balls into 10 piles with 4 balls in each pile. Arrange in two lines, 5 piles per line.

Space piles 2 yards or meters apart side to side. Space the two lines 5 to 10 yards or meters apart front to back.

Mark 4 sections (quadrants) in a circle of 6 feet or 2 meters radius around the hole on the green using string or tees.

Hit 36 chip shots total, 9 shots into each quadrant.

Start at any pile and chip balls to land in the first quadrant. After 9 shots, switch to the next quadrant.

Switch piles after each shot for variety, but always keep the same chipping setup and distance.

Count each ball that stops inside the correct quadrant as a success.

After all 36 shots, enter number of successful shots made out of 36 attempts.

Place 36 balls in two lines of 18 each. Put lines 5 to 10 meters apart. Balls in each line are 30 cm apart.

Mark two circles on the green: a small circle with 2 meter radius and a big circle with 5 meter radius around the hole.

Divide the 36 balls into 2 sets of

First set: chip from first line aiming for the small circle.

Second set: chip from second line aiming for the big circle.

Hit 3 to 5 shots from one line, then switch lines, to keep consistent.

Each ball stopping inside the correct circle for that set is a success.

Count successful balls in the right circles and enter score in the app, out of 36 attempts.

Pick a spot in the rough, on an uphill slope, 5–30 yards from the hole.

Put a target at the hole.

Hit 18 chip shots uphill, trying to stop the ball close to the hole.

Move to a downhill spot in the rough, also 5–30 yards from the hole.

Hit 18 chip shots downhill at the same target.

Every 4 shots, check the results and adjust if needed.

Count a success for every ball that finishes close to the hole (like within 3 feet).

Use the same setup for every shot.

After 36 shots, add up your total successes. Enter score in the app, out of 36 attempts.

Get 36 balls. Make 6 piles with 6 balls in each pile. Use 3 piles for above feet lies and 3 piles for below feet lies.

Put the piles in the rough on a slope, between 5 and 20 yards from the hole. Keep the same type of slope for each group (above or below feet).

Mark 2 zones on the green. Zone A is the front half near the hole. Zone B is the back half, farther from the hole.

From each pile, hit 6 chip shots. Aim 3 shots at Zone A and 3 shots at Zone B.

First, chip from the piles with above feet lies, 6 shots each pile, 3 to each zone. Then do the same with below feet piles.

A shot counts as good if it lands and stays in the zone you aimed for.

When done with all 36 shots, count the good shots and enter your score in the app, out of 36 attempts.

Set up 10 piles of balls in two lines: 5 piles in each line, 3 yards apart, and the lines 5 to 10 yards away from each other. Piles are 5 to 30 yards from the hole.

Use string or tees to mark 4 equal areas around the hole, each 6 feet from the hole.

Hit 36 chip shots, split into 4 groups of

Aim each group at a different area.

Start from a pile, chip 9 balls at the first area, then move to another pile for the next area. Do this until all 4 areas have 9 shots each.

Each shot that stops in the right area is a success.

Count the number of successful shots out of 36 and enter your score in the app.

Set up 3 landing zones on the green, 6 feet apart in a straight line.

Place 3 piles of balls around the chipping area, each pile randomly 5 to 30 yards from the hole. Keep this setup the same.

Divide 36 chip shots into 3 groups of

For the first 12 shots, aim for the first landing zone from any pile.

For the next 12 shots, aim for the second landing zone from any pile.

For the last 12 shots, aim for the third landing zone from any pile.

Count each shot that lands and stays in the correct zone as a success.

Total the successful shots out of 36 and enter the score in the app.