Keep Ball Close To Hole

Arrange 40 balls into 10 piles with 4 balls in each pile. Set the piles in two lines that cross each other near the green. The two lines should be 6 yards apart. Each pile in a line is 2 yards from the next pile.

Pick 3 target flags on the green. Space the targets 6 feet apart in a line or triangle so each one can be aimed at.

Hit 36 bump-and-run shots, in 3 sets of 12 shots. For each set, aim all 12 shots at one of the target flags (Zone 1, Zone 2, Zone 3).

Start at any pile and try to hit the ball so it lands inside a 10-foot circle around the chosen target. Do this for 12 shots, then move to the next target and do it again, until all 36 shots are done.

Use different piles as you like for variety, but always set up the same way for each shot.

Count each shot that stops inside the 10-foot circle as a success.

After all shots, count total successes and enter score in the app, out of 36 attempts.

Place 18 balls on the uphill slope and 18 balls on the downhill slope between 5 and 30 yards from the hole.

Set up 3 targets on the green, spaced evenly in a 10-foot wide area, labeled Target A, Target B, and Target C.

Hit 18 shots from the uphill slope and 18 shots from the downhill slope, for a total of 36 shots.

For each slope, hit 6 shots at Target A, then 6 shots at Target B, then 6 shots at Target C.

Keep the ball setup the same and do not move from your spot on the slope while hitting each group of shots.

Count each shot that lands and stops in the target zone as a success.

After all 36 shots, count and enter the number of successful shots in the app, out of 36 attempts.

Place 36 balls into 6 groups of 6 balls.

Mark 3 target pins on the green, 6 feet apart in a line or arc.

From above feet, hit 18 shots, 6 at each pin in order.

From below feet, hit 18 shots, 6 at each pin in order.

Keep the same ball setup and lie each time. Only change slope.

Count each ball that stops within 3 feet of the target pin as a success.

After 36 shots, add up successes out of 36 and enter score in the app.