Chip 5–15 Yds From Fringe

Divide 36 balls into 3 groups of 12 balls each.

Put 3 targets on the green, each about 3 feet apart.

From about 10-20 yards away, chip 12 balls and try to get them to stop inside Target

Chip 12 balls at Target 2, same way.

Chip 12 balls at Target 3, same way.

Count how many shots stop inside the right target.

Add up your total successful shots out of 36 and enter score in the app.

Put 40 balls into 10 piles with 4 balls in each pile. Arrange in two lines, 5 piles per line.

Space piles 2 yards or meters apart side to side. Space the two lines 5 to 10 yards or meters apart front to back.

Mark 4 sections (quadrants) in a circle of 6 feet or 2 meters radius around the hole on the green using string or tees.

Hit 36 chip shots total, 9 shots into each quadrant.

Start at any pile and chip balls to land in the first quadrant. After 9 shots, switch to the next quadrant.

Switch piles after each shot for variety, but always keep the same chipping setup and distance.

Count each ball that stops inside the correct quadrant as a success.

After all 36 shots, enter number of successful shots made out of 36 attempts.

Place 3 target zones on the green, 6 feet apart, in a line from the hole.

Use 36 balls, split into two groups of

Chip 18 balls from above feet level, 6 balls to each zone.

Chip 18 balls from below feet level, 6 balls to each zone.

Count balls that stop inside the correct zone.

Add up total successful shots and enter score in the app, out of 36 attempts.

Make two piles of balls for each player between 5 and 30 yards from the hole, anywhere in the chipping area, on any surface.

On the green, make two bullseye zones around the hole: inner circle with 6-foot radius and outer ring from 6 to 15 feet.

Each player hits 36 chips: 18 from each pile.

Try to stop the ball in the inner bullseye (best), then outer bullseye (good), or avoid missing both (bad).

Switch piles after 18 shots, finish all 36 shots.

Count how many balls stop in the bullseye zones.

After 36 shots, record the number of balls in the bullseyes as your score. Enter this total in the app out of 36 attempts.

Make 10 piles with 4 balls in each pile, for a total of 40 balls. Put these piles in two lines that cross each other, with 5 piles in each line.

Place the piles on grass, 5-30 yards from the hole. The lines should be 5-10 yards apart, and each pile should be 2 yards apart.

Around the hole, make two circle target zones using string or tees: a small Bullseye (6 feet from hole) and a bigger Bullseye (15 feet from hole).

Hit 36 chip shots, in 3 sets of 12 shots.

For each set, chip towards the Bullseye zones, switching piles each time.

Balls stopping in the small Bullseye count as higher score. Balls in the big Bullseye also count, but less. Both are counted as a successful chip.

When finished, count all balls in the small or big Bullseye out of 36 tries, and enter the total in the app.

Pick a spot in the rough, on an uphill slope, 5–30 yards from the hole.

Put a target at the hole.

Hit 18 chip shots uphill, trying to stop the ball close to the hole.

Move to a downhill spot in the rough, also 5–30 yards from the hole.

Hit 18 chip shots downhill at the same target.

Every 4 shots, check the results and adjust if needed.

Count a success for every ball that finishes close to the hole (like within 3 feet).

Use the same setup for every shot.

After 36 shots, add up your total successes. Enter score in the app, out of 36 attempts.

Make 10 piles of 4 balls each, in two lines of 5 piles.

Put piles on grass, 5–30 yards from the hole, lines 5–10 yards apart, piles in each line 2 yards apart.

On the green, mark three landing zones in a straight line, 6 feet apart.

Hit 36 chip shots, 12 at each landing zone.

Hit from different piles for each shot. Do 12 shots into the first zone, then 12 into the second, then 12 into the third.

Count shots that land fully in the target zone.

After 36 shots, enter the number of successful shots in the app, out of 36 attempts.